In Unix, as a matter of philosophy, (almost) everything is a file, thus sound cards are treated as 'Character Files.' The kernel syscalls are as per the POSIX specification - so 'open','close','ioctl','read','write'. Access to the soundcard is done through the driver interface, as a file under '/dev/'. I found the sound card. But where is its control panel? Favorite Answer. The Windows operating system includes a utility program for adjusting the levels, or volume, of sound going in and out of the sound card. You can access this utility, called Windows Volume Control, by double-clicking on the small loudspeaker icon near the bottom right-hand corner of your screen. Would a broken sound card make it so the 'sound, video and game controller' section not show up in the device manager? You can get relatively decent sound cards these days for dirt cheap. It might just be worth getting a new card instead of the headache of troubleshooting a faulty onboard card.

Modern PCs are usually equipped with a 'sound card', which allows sounds to be captured and reproduced by the computer. EchoLink relies on the sound card (or built-in equivalent) to exchange audio with other stations on the Internet.

The most common configuration for EchoLink is to connect a pair of amplified speakers to your computer's 'speaker out' connector, and to plug a microphone into the 'mic in' jack. Many other multimedia programs work with this same configuration.

Playback Volume

The Windows operating system includes a utility program for adjusting the levels, or volume, of sound going in and out of the sound card. You can access this utility, called Windows Volume Control, by double-clicking on the small loudspeaker icon near the bottom right-hand corner of your screen. You will see a set of 'sliders' similar to the diagram below.

Be sure the 'Volume Control' and 'Wave' sliders are about halfway up, and the 'Mute' box is not checked for either one. You may wish to check Mute for all other sliders, or slide them down to the bottom, to prevent interference.

Your system may use names other than Volume Control and Wave, such as Master Volume and Wave Out.

Recording Volume

A separate set of controls sets the levels, or volume, for the microphone. To access these controls, follow the steps above for Playback Volume, and then do the following:

From the Options menu, choose Properties.
In the section marked 'Adjust volume for', choose 'Recording'.
Choose OK.

You will see a different set of 'sliders', similar to the diagram below.

Sound Cards 7.1

The Recording Volume controls vary considerably from computer to computer. In the example shown above, there are separate controls for Line and Microphone. If you have a microphone connected to the computer's mic jack, slide the Microphone slider halfway up and check the Select box for it. Your computer may also have a 'master' recording slider; if so, move it halfway up. Move all other sliders to the bottom to prevent interference.

If you are using EchoLink in Sysop mode, you will probably have your receiver's audio connected to the computer's Line In connector, rather than Mic. If so, raise the Line slider, and lower (or de-select) the Microphone slider.

Access Sound Cards Online

Monitoring Your Levels

While you are speaking with another station using EchoLink, watch the Audio Level Meter near the bottom of the screen as you speak. The meter should jump at least into the yellow area on voice peaks, but should not go full-scale. Adjust the Microphone slider (described above), if necessary.

Access Sound Cards & Media Devices Driver Download